0102030405
Scraper Cleaning Machine


01
7 Jan 2019
This equipment is used for scraper cleaning of printing machines, such as cleaning residual solder paste, dust, etc. The "scraper cleaning machine" uses technologies such as high-pressure spray cleaning, ultrasonic cleaning, rolling rinsing, large-flow fan hot air drying, etc. to ensure the cleaning effect. Integrated cleaning, rinsing, air cutting and drying functions. The time and speed of adding and draining liquid, cleaning and rinsing can be set through the human-machine interface.
Technical Parameters
Technical Parameters | |
Model | FR-670 |
equipment dimensions | 1440*1150*1240 |
Diameter of the working basket | 200mm |
Maximum length of squeegee | 600mm |
workbasket loads | 20KG |
gas pressure range | 0.4-0.6Mpa |
Tank capacity | 60L |
Spray pressure | 0.15-0.3Mpa |
Maximum power | 18KW |
voltage/frequency | 380V/50HZ |
Recommended cleaning agents | Aqueous cleaning agent FR-6001 |
Cutter Cleaning Machine





























FAQ
Q: Poor cleaning effect:
1. Make sure the cleaning time is long enough to allow the scraper to be thoroughly cleaned.
2. Check whether the filter system of the scraper cleaning machine is working properly and clean or replace the filter.
Q: The cleaning machine makes too much noise:
1. Check the cleaning machine’s transmission system, such as transmission belts or gears, to see if they need to be lubricated or replaced.
2. Check whether the pump and motor of the cleaning machine are working properly. If there is abnormal noise, it may be necessary to repair or replace parts.
Q: The cleaning fluid is consumed too quickly:
1. Adjust the spray pressure and spray mode of the cleaning machine to avoid over-spraying.
2. Check for leaks or dripping, and repair or replace seals and pipes.
Q: Cleaning machine failure or shutdown:
1. Check whether the power supply and power cord are properly connected to ensure stable power supply.
2. Check whether the control panel and buttons are working properly and ensure that the device switches and settings are correct.
3. Check the sensors and safety devices to ensure they are functioning properly and not triggering false signals.